Installing The Miter Handle; Saw Blade Wrench Storage; Installing The Hold-Down Clamp Assembly; Unlocking The Slide Carriage - Craftsman 137.407530 Operator's Manual

INSTALLING THE MITER HANDLE
(FIG. C)
1. Insert the miter handle (1) into the
hole in front of the miter saw and
align the hole (2) on the miter
handle (1)with the hole (3)in the
front of the table.
2. Thread the screw (4) through the
hole (3) in the table into the hole (2)
on the miter handle (1).
3. Tighten the screw (4) with a
screwdriver.
Fig. C
3
SAW BLADE WRENCH STORAGE
(FIG. D)
For convenient storage and prevention
of loss, there is a slot in the side of the
trigger switch handle (1) for storing the
blade wrench (2) when not in use.
Fig. D
iNSTALLiNG THE HOLD-DOWN
CLAMP ASSEMBLY (FIG. E, F)
Place the hold-down clamp assembly (1)
in one of the mounting holes (2)located
behind the fence.
Fig. E
2 ................. i i I' _
Fig. F
2
2
UNLOCKING THE SLIDE CARRIAGE
(FIG. G)
After removing the saw from the carton,
loosen the slide carriage lock knob (1),
located on the left side of the slide
_,___. carriage. When transporting or storing
the miter saw, the slide carriage should
always be locked in position.
2 Fig. G