Miter Lock Handle; Dust Guide; Dust Bag - Craftsman 315.212340 Operator's Manual

Asmentioned previously, thesawhasbeen factory
assembled a ndadjusted. Themiterlockhandle, d ust
guide, a ndbladearetheonlypartsthathaveto be
installed.
MITER LOCK HANDLE
See Figure 9.
Cut the tie-wraps holding the saw arm and the miter lock
in place. To install the miter lock handle, place the thread-
ed stud into the threaded hole in the control arm. Turn
clockwise to tighten.
EXHAUST
PORT
DUST GUIDE
TO
LOOSEN
Fig. 10
DUST BAG
See Figure 11.
A dust bag is provided for use on this miter saw. It fits
over the dust guide on the upper blade guard. To install,
squeeze the two metal clips to open the mouth of the bag
and slide it on to the dust guide. Release the clips. The
metal ring in the bag should lock in between the grooves
on the dust guide.
To remove the dust bag for emptying, simply reverse the
above procedure.
MITER
LOCKHANDLE
TO CONTROL
TIGHTEN ARM
MITER
TABLE
Fig. 9
DUST GUIDE
See Figure 10.
To install the dust guide, place the end marked INSERT
over the exhaust port in the upper blade guard. Turn the
guide so that the open end is facing down or toward the
rear of the saw.
DUSTBAG
DUSTGUIDE
Fig. 11
16