Assembly - Craftsman 315.212380 Operator's Manual

UNPACKING
This product requires assembly.
• Carefully lift saw from the carton by the carrying handle
and the saw base, and place it on a level work surface.
NOTE: This saw is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
• This saw has been shipped with the saw arm secured
in the down position. To release the saw arm, push
down on the top of the saw arm, cut the tie-wrap, and
pull out on the lock pin.
• Lift the saw arm by the handle. Hand pressure should
remain on the saw arm to prevent sudden rise upon
release of the tie wrap.
• Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
• Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
• The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures
explained in this manual.
If any parts are damaged or missing, please call
1-800-932-3188 for assistance.
A
WARNING: If any parts are damaged or missing
do not operate this product until the parts are
replaced. Failure to heed this warning could result
in serious personal injury.
WARNING: Do not attempt to modify this product
or create accessories not recommended for use with
this product. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
A
WARNING: Do not connect to power supply until
assembly is complete. Failure to comply could result
in accidental starting and possible serious injury.
A
WARNING: Always make sure the compound
miter saw is securely mounted to a workbench or an
approved workstand. Failure to heed this warning
can result in serious personal injury.
ASSEMBLING THE STAND-n-STOW
TM
CABINET
See Figure 8.
This product requires assembly.
• Insert the supplied lock nut into the hex nut pocket.
• Align the reinforcement plate holes with the tab on the
bottom of the base and the screw hole in the base.
• Place supplied washer and lock washer onto the
supplied screw.
• Insert screw into the hole in the base.
• Turn clockwise to tighten screw.
• Repeat above steps until all four screws have
been inserted and tightened into base and both
reinforcement plates are installed.
HEXNUT BASE
POCKET
REINFORCEMENT _o_ WASHER
PLATE ' _ LOCKWASHER
oSCREW
SCREW
'_CK WASHER
WASHER
TABHOLE
REINFORCEMENT
PLATE
TAB
15
Fig. 8