Miter Lock - Unlocked View; Location Of Hex Lock Nut View; Location Of Hex Socket Cap Screw - Craftsman 113.198251 Operator's Manual

Miter Lock Handle
Fig_ 149 - Miter Lock - Unlocked
2. With a 3/16 inch hex "L" wrench find the
1/4-20 hex socket cap screw through the hole
in the rear of the ann cover° To tighten turn
the wrench clockwise approximately 1/4 turn.
(Figure !50)
\
Fig. 150 - Location of Flex Socket Cap Screw
3. Lock the miter lock and try again to move
the atrn, Readjust if necessary.
4. If it becomes extremely difficult to push
the miter lock into the locked position too
much adjustment has been made. Turn the
wrench counterclockwise one half the
amount of the last adjustment and try again
to lock the arm.
Rip Lock
The n_plock locks the carthage in any position
along the length of the ann° If the carriage
can be easily moved by pushing and pulling
on theyoke handle when the rip lock is in the
locked position an adjustment is required.
1, Hold the rip lock in the unlocked position
and with a 7/16 inch wrench tighten the 1/4-
20 hex lock nut 1/4 turn. (Figure 151)
Arm Track
\,,t//
Spring Cocknut
Lever Cam Carriage
Bolt
Fig 151 - Location of Flex Lock Nut
2. Lock the rip lock and try again to move the
carriage. Make additional adjustments if
necessary.
3oPlace the rip lock in the unlocked position
and move the carriage back and forth from
stop to stop. If the carriage is difficult to
move at any point or you can feel the rip lock
dragging on the track the adjustment is too
tight, Loosen the hex nut one half the
amount of the last adjustment and try again.
77