Table of Contents
Advertisement
STEP 4:
(SEE FIGURE 4)
•
Assemble the landside to frog using two 3/8 x 1" plow
bolts and 3/8" hex nuts. Do not tighten yet.
3/8" HEX NUT
/
FIGURE 4
STEP 6:
(SEE FIGURE 6)
•
insert 1/2 x 1-1/2" carriage bolt through frog and
standard, securing it with a 1/2" hex nut. Do not
tighten yet.
•
insert a 1/2 x 1-1/2" hex bolt through tab at bottom of
standard. Place the 1/2" square nut between the tab
and frog, threading the hex bolt into the nut until tight.
•
Tighten fasteners assembled in steps 4-6 at this time.
1/2"x 1-112"
0i
1/2" HEX NUT
,/
I
/
i
I
112 x 1-112"
HEX BOLT
FIGURE 6
STEP 5:
(SEE FIGURE 5)
Attach the standard to the frog using a 1/2 x 2" plow
bolt and 1/2" hex nut. Do not tighten yet.
\
1/2" HEX NUT
j
.'
1/2 x 2" PLOW BOLT
\\..
FIGURE 5
STEP 7:
(SEE FIGURE 7)
*
Insert the standard between the beams and fasten
together using the lower hole in the standard with one
1/2 x 1-3/4" hex bolt and 1/2" lock nut.
*
Attach end of threaded tube to upper hole on side
of standard using one 1/2 x 1-1/2" hex bolt, 1/2" flat
washer, a 9/16" spacer placed inside hole of standard
and a 1/2" lock nut.
=
Tighten fasteners assembled in this step but make
sure threaded tube is free to pivot.
1/2 x 1-1/2" HEX BOLT
_.
1/2" FLAT WASHER
/
h_,_ _
9/18" SPACER
/
.
(
112 x 1-314"
HEX BOLT
1/2" LOCK
NUT
Call 1-866-576-8388
for missing parts or assembly help
DO NOT RETURN TO STORE
FIGURE 7
7
Advertisement
Table of Contents
