Advertisement
LAWN TRACTORS
WiTH DUAL SUSPENSION
BRACKETS
STEP 22: iNSTALL SIDE PLATES
(SEE FIGURE 21)
•
Remove any bolts present in the mounting holes on
the left side of the tractor frame. Do not remove bolts
from right side of frame until done with left side plate.
Fasten the left (long) side plate to the tractor frame
using three 3/8" x 1" hex bolts (E), 3/8" small washers
(FF), and 3/8" lock washers (DD). If there is a bracket
like the one shown with dotted lines, use a 3/8" large
washer (HH) as a shim on the rear bolt. Do not
tighten
yet. Repeat for the right (long) side plate.
3/8" LARGE
WASHER (HH)
(if
:led)
FIGURE 21
(3) 3/8" SMALL
(3) 3/8" × 1"
WASHERS (FF)
HEX BOLTS (E)
(3) 3/8" LOCK
WASHERS (DD)
STEP 23: iNSTALL FRAME BRACE
(SEE FIGURE 22)
•
Install the frame brace between the side plates using
two 1/2" x 1-3/4" bolts (B), large 1/2" large washers
(JJ), 1/2" spacers (Y) and 1/2" nylock nuts (O). Use the
second hole from the bottom in the plates. Tighten.
•
Tighten 3/8" x 1" hex bolts (E) in side plates only until
they are snug and the lock washers are flattened.
•
Skip to step 25 on page 15.
1/2" x 1-3/4"
v
HEX BOLT (B)
_ 1/2" SPACER(Y)
/
1/2" LARGE
WASHER
(JJ)
1/2" NYLOCK NUT (O)
FRAME BRACE
FIGURE 22
14
GARDEN
TRACTORS
WiTH DUAL
SUSPENSION
BRACKETS
STEP 24: iNSTALL SIDE PLATES
(SEE FIGURE 23)
•
Remove any bolts present in the mounting holes on
the left side of the tractor frame. Do not remove bolts
from right side of frame until left side plate has been
installed.
Install the left (short) side plate with the pin to the
outside using two 3/8" x 1" hex bolts (E) and 3/8" lock
washers (DD). Tighten only until bolts are snug and
lock washers are flattened. Repeat for the right side
plate.
Install a 3/4" washer (KK) and a long hairpin cotter
(Z) to the pin in each side plate. Remove them while
mounting the scoop.
LEFT (GT)
SiDE PLATE
d_L_-..@
0.. "%
_WASHERS
(DD)
/
_
(2) 3/8" x 1"
LONG
HEX BOLTS(E)
HAIRPIN
3/4" WASHER (KK)
COTTE R (Z)
FIGURE
23
Advertisement
