Advertisement
STEP 9: iNSTALL DUMP PIVOT BRACKET
(SEE FIGURE 8)
•
Install a 1/8" x 1-1/2" cotter pin (CC) to the inside hole
in the shaft shown in figure 8, and then install a 1"
washer (LL) onto the shaft. Apply grease to the end of
the shaft and install the dump pivot bracket assembly
onto the shaft. Install a 1" washer (LL) onto the shaft
and secure it using a 1/8" x 1-1/2" cotter pin (CC).
1/8" x 1=1/2"
COTTER PIN (CC)
\
j_'_
1" WASHERS (LL)
1/8" x 1=1/2"
COTTER PIN (CC)
/
DUMP PIVOT
BRACKET
FIGURE 8
STEP 11 : INSTALL TILT STOP BRACKETS
(SEE FIGURE 10)
•
Install a tilt stop bracket (QQ) to each side of the
bucket using a 3/8" x 1" carriage bolt (J), a small 3/8"
washer (FF) and 3/8" nylock nut (R). Do not tighten
the nuts until step 28.
TiLT STOP
BRACKET (QQ)
3/8" NYLOCK
_'_'-_
NUT (R)
3/8" x 1" j_o
3/8" WASHER (FF)
CARRIAGE BOLT (J)
FIGURE 10
STEP 10: iNSTALL DUMP CONTROL ROD
(SEE FIGURE 9)
•
install a 1/8" x 1=1/4" cotter pin (BB) into the inside hole
in each end of the dump control rod. Spread the ends
of the cotter pins and wrap around the rod. Install a 5/8"
washer (11) onto each end of the control rod.
Install the dump control rod to the dump pivot bracket
and bucket. Fasten using two 5/8" washers (11)and
1/8" x 1-1/4" cotter pins (BB). Spread the ends of the
cotter pins and wrap around the rod.
1/8" x 14/4"
COTTER PiN (BB)
5/8" WASHERS (ll)
1/8" x 1=1/4"
COTTER
PINS (BB)
1/8" x 14/4"
COTTER PiN (BB)
5/8" WASHERS (ll)
DUMP
CONTROL
ROD
FIGURE 9
STEP 12: INSTALL LiFT HANDLETUBE
(SEE FIGURE 11)
•
Install the lift handle tube into the index bracket using
two 5/16" x 1-3/4" hex bolts (G) and 5/16" nylock nuts
(s).
5/16" NYLOCK
NUTS (S) _\®_
LiFT HANDLE
TUBE
5/16" × 1=3/4"
HEX BOLT (G)
iNDEX
BRACKET
FIGURE 11
lO
Advertisement
