Craftsman 486.244412 Operator's Manual page 11

STEP 5: (SEE FIGURE 19)
• Assemble one 5/16" jam nut (I) approximately 3/4"
onto threaded end of control cable that has no rubber
cap or preassembled nuts. Assemble threaded cable
end through round hole in cable mount bracket and
secure with another 5/16" jam nut (I). Tighten.
NOTE: Some adjustment of jam nuts may be required
after blade assembly is completed.
CABLE MOUNT ___ ___
BRACKET 314"
5116" JAM
NUT (I)
5116" JAM
NUT (I)
f
CHANNEL ASSEMBLY
REAR--_
FIGURE 19
(Left Hand Side View)
STEP 6: (SEE FIGURE 20)
• Assemble ball end of control cable up through hole in
cable end fitting and pull until ball slips inside curled
edge of fitting. If ball won't slip under edge of curl, it
will need to be inserted through open end of curl.
• Assemble 1/4" x 1-1/2" (B) hex bolt down through the
cable end fitting, the 5/8" long spacer (T) and the left
hand hole in the channel assembly. Secure with a
1/4" nylock nut (J). Tighten.
NOTE: Make sure the cable mount bracket is aligned with
the cable end fitting to prevent binding of cable. The other
end of the control cable will be attached in a later step.
_1_ ] 1/4" x 1-1/2"
CABLE END HEX BOLT (B)
FITTING
STEP 7: (SEE FIGURE 21)
• To attach the blade to the channel assembly, align
the notched holes in the pivot plate with the notched
holes in the blade. Insert a 1/8" x 1-1/4" cotter pin (P)
down through the hole at the bend in the blade pivot
shaft. Spread the ends of the pin. From the left side
insert the blade pivot shaft, bend facing top of blade,
through the notched holes. Secure the shaft with
another 1/8" x 1-1/4" cotter pin (P) through the end
hole in the shaft. Spread the ends of the pin.
• Remove the plastic cap and one 3/8" hex nut from the
bolt in the blade adjust spring. Adjust the remaining
3/8" hex nut down approximately 1" onto the bolt
threads. Hook the spring over the spring mount rod.
Place the bolt up through the hole in the top edge of
the blade and reassemble the other 3/8" hex nut to
the bolt and tighten down against the top edge of the
blade. Replace the plastic cap over the end of the bolt
threads.
118"x 1-114" _ PLASTIC
COTTER PIN (P)'=_ _ CAP ""_#
/_t3/8" HEX NUT
_h_ (TOP)
BLADE 3/8" HEX NUT
PIVOT \
\ (BOTTOM)
SHAFT \
BLADE
SPRING
MOUNT
ROD
FIGURE 21
BLADE
ADJUST
\ SPRING
PIVOT PLATE
118" x 1-114"
COTTER PIN (P)
NOTCHED HOLE
(Right Hand Side View)
ASSEMBLY
I
I
_ !
!
1/4" NYLOCK NUT (J) _
HOLE
REAR
FIGURE 20
(Left Hand Side View
11