Setup; Unpacking; Inventory - Woodstock SHOP FOX W1758 Owner's Manual

Unpacking

This machine has been carefully packaged for safe trans-
portation. If you notice the machine has been damaged
during shipping, please contact your authorized Shop Fox
dealer immediately.

Inventory

The following is a description of the main components
shipped with the Model W1758. Lay the components out
to inventory them.
Note: If you can't find an item on this list, check the
mounting location on the machine or examine the pack-
aging materials carefully. Occasionally we pre-install cer-
tain components for safer shipping.
Box 1 Inventory (Figures 2–3)
A. Lathe Unit ..................................................1
B. Faceplate 6" ................................................1
C. Hardware Bag ..............................................1
D. Knockout Tool ..............................................1
E. Flat Wrenches 32mm ......................................2
F. Spur Center .................................................1
G. Live Center .................................................1
H. Tool Rest Handle ...........................................1
I. Hex Wrenches 3, 4, 6mm ............................1 Ea
J. Cap Screws M8-1.25 x 35mm ............................8
K. Quill locking lever .........................................1
L. Lock Washers 8mm ........................................8
Box 2 Inventory (Figure 4)
M. Right Leg ....................................................1
N. Left Leg .....................................................1

SETUP

Keep machine disconnected
from power until instructed
otherwise.
W1758 Owner's Manual (Mfg. Since 4/10)
B
Figure 2. Box 1 inventory.
F
Qty
K
Figure 3. Hardware bag inventory.
Qty
Figure 4. Box 2 inventory.
-10-
A
C
E
D
H
G
I
J
L
N
M