Woodstock SHOP FOX W1758 Owner's Manual page 15

W1758 Owner's Manual (Mfg. Since 4/10)
3. Using the 6mm hex wrench, secure the lathe to the
legs with the eight cap screws and lock washers, as
shown in Figure 8.
4. Install the handle into the tool rest, as shown in
Figure 9.
5. Align the quill keyway with the entry hole of the
quill lock lever (see Figure 10), then install the
lever into the tailstock so that the end of it mates
with the quill keyway.
Note: Make sure the dog-end of the lock lever fits
into the quill keyway so that the quill can move in
and out of the tailstock without rotating.
To safely secure a center in the tailstock quill, the
quill locking lever must be aligned with the quill
keyway and fully tightened. Failure to follow this
procedure could result in the spinning workpiece or
center being thrown from the lathe, causing death
or serious personal injury.
6. Secure the digital readout to the top of the head-
stock, as shown in Figure 11.
Figure 8. Securing lathe to legs.
Figure 9. Installing tool rest handle.
Quill Locking
Lever
Figure 10. Quill locking lever installed.
Figure 11. Digital readout installed onto
the headstock (viewed from the back).
-13-
Quill
Keyway