Test Run - Woodstock SHOP FOX W1758 Owner's Manual

Test Run

Test Run
Once the assembly is complete, test run your machine to
make sure it runs properly and is ready for regular opera-
tion.
The test run consists of verifying the following: 1) The
motor powers up and runs correctly, and 2) the switch
disabling mechanism works correctly.
If, during the test run, you cannot easily locate the source
of an unusual noise or vibration, stop using the machine
immediately, then review Troubleshooting on Page 30.
If you still cannot remedy a problem, contact our Tech
Support at (360) 734-3482 for assistance.
To test run the machine, do these steps:
1. Make sure you understand the safety instructions at
the beginning of the manual and that the machine is
setup properly.
2. Make sure all tools and objects used during setup are
cleared away from the machine.
3. Connect the machine to the power source.
4. Turn the lathe ON by lifting up on the ON/OFF
switch, and verify that it operates correctly.
— When operating correctly, the machine runs
smoothly with little or no vibration or rubbing
noises.
— Investigate and correct strange or unusual noises
or vibrations before operating the machine fur-
ther. Always disconnect the machine from power
when investigating or correcting potential prob-
lems.
5. Turn the machine OFF by pushing down on the ON/
OFF switch.
6. Remove the switch disabling key (see Figure 12).
7. Try to start the machine with the switch.
— If the machine does not start, the switch disabling
feature is working as designed.
— If the machine starts, immediately stop the
machine. The switch disabling feature is not work-
ing correctly. Call Tech Support for help.
W1758 Owner's Manual (Mfg. Since 4/10)
Figure 12. Removing lockout key from
-14-
Tie back long hair, roll
up long sleeves, and
remove loose clothing,
jewelry, or gloves to
prevent getting caught
in moving parts.
switch.