Configuring The Monitoring Console; Storing Modem Information - Intergraph InterSite Server Monitor Setup Manual

The Selection pane contains the following two entries:
u
Microsoft Windows Network, for in-band communication with the server.
u
SMM Modem Transport, for out-band communication with the server.

Configuring the Monitoring Console

Once you install ISM software on the monitoring console, you can configure the modem
information, the pager service, and user accounts.
NOTE The instructions in this section and following sections assume that a modem is already
connected internally or externally to the monitoring console.
For the monitoring console to receive the alerts sent from the server, the LANDesk Server
Manager Console, and SNMP Event Viewer should be running at all times. In Windows NT
4.0, use Explorer to copy the applications to the Start menu. In Windows NT 3.51, use
Program Manager to copy the applications to the Startup program group.

Storing Modem Information

When you start LANDesk Server Manager Console for the first time, the Communications
Settings dialog displays so you can configure the monitoring console's modem. You may
choose to enter the modem information immediately or at a later time. The dialog also
displays when the defined modem cannot be initialized.
NOTE The modem information is for the modem connected to the monitoring console, not the PC
Card modem installed in the ISM board on the server.
You can perform the following procedure on the monitoring console.
To store modem information:
1. Open LANDesk Server Manager Console from the Windows NT 4.0 Start menu, or from
the LANDesk Server Manager group in Windows NT 3.51 Program Manager.
2. From the Configure menu, select Communications. (You may also double-click SMM
Modem Transport in the Selection pane of the LANDesk Server Manager window.) The
Communications Settings dialog displays.
21