Installing The Ism Software - Intergraph InterSite Server Monitor Setup Manual

16

Installing the ISM Software

NOTE Installation and configuration tasks require Administrator privileges. Use an account with
Administrator privileges on the system to which you are installing ISM software.
To install ISM software on the server or monitoring console:
1. Insert the InterSite Server Monitor Disk 1 diskette into the floppy disk drive.
2. To start Setup, do one of the following:
In Explorer or File Manger, select the directory window for the diskette in the floppy
disk drive; then double-click
Select Run from the Start menu, or select Run from the File menu in File Manager;
then type the following, where drive is the drive letter for the floppy disk drive, and
click OK:
drive:\setup
In Windows NT 4.0, select Add/Remove Programs from the Control Panel, and click
Install on the Install/Uninstall tab.
3. Follow the instructions displayed as Setup installs the ISM software. Remove and insert
the remaining diskette when prompted by Setup.
4. During installation, note the following:
If installing ISM software on a server, select all software options except for OEM
Snap-In Modules. If installing on a monitoring console system, select only Server
Manager Console and SNMP Event Forwarder.
When prompted for a path to the destination directory for the product files, key in a
new path or leave the default path as displayed. By default, the product directory is
C:\SMM32.
Ignore messages about version conflicts or files in use for the
MSVCRT20
of these files. If you see this message, use Explorer or File Manager to rename the
older DLL files and select Retry at the installation prompt.
When asked if you want to view the
The
can review it later.
5. Remove any diskettes in the floppy disk drive.
. files unless you see a message saying your system has older versions
DLL
. file is copied to the system disk and the program group, so you
SMREADME WRI
. .
SETUP EXE
. file or exit, click Exit Setup.
SMREADME WRI
. and
CTL3D32 DLL