Configuring The Ism Board On The Server - Intergraph InterSite Server Monitor Setup Manual

6. Do one of the following:
If you are configuring a monitoring console, restart your system; then go to "Using
LANDesk Server Manager" in this chapter.
If you are configuring a server with an ISM board, go to the next section,
"Configuring the ISM Board on the Server," and then go to "Configuring Event
Forwarder on the Server" in this chapter.

Configuring the ISM Board on the Server

Intergraph configures the IRQs, port, and shared memory locations for the ISM board before
shipment. If reconfiguring the system, or configuring the ISM board for the first time, use the
following instructions.
To configure the ISM board:
1. Restart the system, and press
process. The AMIBIOS Setup Main Menu displays.
2. From the Setup menu, double-click the Chipset icon (or select the icon and press
3. Use the mouse or the arrow keys to move to the following items in the board list.
Server Monitor, I/O Select
Server Monitor, DMA Select
Server Monitor, IRQ Select
Server Monitor, Memory Select
4. To set the value of each item, click the item with the mouse, or highlight it and press
ENTER
the items.
5. To exit the menus, either click the system control on the menu window, or press
6. Select Save Changes and Exit to exit the BIOS setup. Allow the configuration
information to be written and the system to finish restarting.
Continue with the instructions in the next section, "Configuring Event Forwarder on the
Server."
DELETE
. An Options menu displays for the highlighted item, allowing you to select one of
at the system memory check during the bootup
17
).
ENTER
.
ESC