Kyocera TASKalfa 6550ci Operation Manual page 329

Border Erase Default
Set the default width to be erased as a border. The table below shows the measurement ranges that can be set.
Input units
Inch
Metric
NOTE:
Refer to page 4-18 and page 6-26 for Border Erase.
Use the procedure below to set the default border erase width.
1
Press the System Menu key.
2
Press [Common Settings], [
3
Press [+] or [–] for the Border and Gutter width to erase.
You can use the numeric keys to enter the number directly.
4
Press [OK].
Border Erase to Back Page
Select the Border Erase Method for Back Page of a sheet. The table below shows the available settings.
Item
Same as Front Page
Do Not Erase
NOTE:
Refer to page 4-18 and page 6-26 for Border Erase.
Use the procedure below to specify the border erase setting for the back side of the original page.
1
Press the System Menu key.
2
Press [Common Settings], [
Page.
3
Press [Same as Front Page] or [Do Not Erase].
4
Press [OK].
0 to 2" (in 0.01" increments)
0 mm to 50 mm (in 1 mm increments)
], [Next] of Function Defaults, [
Border Erase performed in the same setting as the front page
No Border Erase performed on the back page
], [Next] of Function Defaults, [
9-23
Default Setting (System Menu)
Range
] and then [Change] of Border Erase Default.
Description
] and then [Change] of Border Erase to Back
9