Changing Scan Settings - Kyocera TASKalfa 650c Operator's Manual

3 USEFUL FUNCTIONS AND SETTINGS

Changing Scan Settings

You can change the scan settings in the "HS Remote Scan Driver" dialog box. The dialog box consists of 3 tabs: Page
Settings, Image Settings, and Color Settings. The components of the dialog box are as described below.
1) Menu Bar
You can select various functions from the following menus:
[File]:
- Page Settings—Click to display the [Page Settings] tab.
- Image Settings—Click to display the [Image Settings] tab.
- Color Settings—Click to display the [Color Settings] tab.
- Scan—Click to start remote scanning and acquire the image.
- Close—Click to close the Remote Scan driver.
[Edit]:
- Reset Settings—Click to reset all the settings to the factory defaults.
[Devices]:
- Discovery—Click to add a new same series MFP to connect to. Clicking the menu displays the Local Discovery
dialog box.
P.20 "Registering additional same series MFPs"
- Select HS—Click to change the target device from which scans are retrieved.
P.20 "Switching between connections"
[Help]:
- Help—Click to display Online Help.
- About—Click to display version information.
2) [Page Settings]/[Image Settings]/[Color Settings] Tabs
You can set the various scan settings in each tab.
P.17 "[Page Settings] tab"
P.18 "[Image Settings] tab"
P.19 "[Color Settings] tab"
3) [Scan]
Click this button to start remote scanning and acquire the image.
4) [Cancel]
Click this button to exit the Remote Scan driver.
5) Status Bar
The status bar on the bottom of the dialog box shows the communication status and the IP address of the connected
same series MFP.
16

Changing Scan Settings

1
2
3
4
5