Connecting To The Same Series Mfp - Kyocera TASKalfa 650c Operator's Manual

Connecting to the same series MFP

When you use the Remote Scan driver and access your machine for the first time, the Local Discovery dialog box
appears. In this case, you can either use the local discovery feature to automatically search the network for your machine
or enter the MFP's IP address manually.
P.11 "Searching MFPs automatically"
P.12 "Entering IP addresses manually"
To find your same series MFP under the SNMPv1/v2 environment, the SNMP read community name that is set for the
target same series MFP must be "public." For help, consult the administrator.
The following procedures can also be used for registering additional same series MFPs. If you wish to scan originals
remotely from multiple same series MFPs, select [Devices] > [Discovery] in the "HS Remote Scan Driver" dialog box
and follow the procedure below to register additional same series MFPs.
P.20 "Registering additional same series MFPs"
Searching MFPs automatically
1 Click [Start Discovery].
The local discovery feature locates same series MFPs on the network.
You can quit the process by clicking [Stop Discovery].
Devices in different segments may not be found. If you cannot find your machine, find it manually using
[Manual Selection].
P.12 "Entering IP addresses manually"
The search process may take a long time especially when many clients exist on the network. In this case,
change the discovery settings using [Advanced].
P.21 "Changing Network Discovery Settings"
The local discovery feature cannot detect same series MFPs on the IPX/SPX network.
The target same series MFPs may not be found due to the SNMP settings. In this case, verify and/or
change the settings using the SNMP Settings dialog box. For help, see the following section:
P.22 "Changing SNMP settings"
2 BASIC OPERATION
Connecting to the same series MFP 11