Select Security Mode - Kyocera TASKalfa 650c Operator's Manual

1.SETTING UP WIRELESS NETWORK

Select security mode

After specifying the SSID, you must select the security mode for your wireless network.
The procedure to configure the security mode varies depending on the security mode that you select.
P.19 "Selecting WPA/WPA2 security mode with EAP-TLS protocol"
P.25 "Selecting WPA/WPA2 security mode with PEAP protocol"
P.29 "Selecting WPAPSK/WPA2PSK security mode"
P.31 "Selecting WEP security mode"
P.33 "Selecting no security mode"
If you are not sure what security mode to select, see the following section to determine the security mode.
P.11 "Determine the security mode"
Selecting WPA/WPA2 security mode with EAP-TLS protocol
Using the WPA/WPA2 with the EAP-TLS protocol, you must install user certification file and CA certification file in the
equipment. This equipment uses the user certification file to authenticate the access rights to the wireless network, and
the RADIUS server authenticate this equipment using the CA certification file.
When using the WPA/WPA2 with the EAP-TLS protocol, you must install the CA certification file and user certification
file in the equipment using COMMAND CENTER first. For instructions on how to install the CA certification and user
certification files using COMMAND CENTER, refer to COMMAND CENTER Guide.
1 Press the [WPA] or [WPA2] and press the [NEXT].
The AUTHENTICATION SETTINGS screen is displayed.
When the [WPA] or [WPA2] is selected, TKIP or AES(CCMP) can be selected.
1 SETTING UP WIRELESS NETWORK
Setting Up the Infrastructure Mode 19