COMMAND CENTER USER Mode
The same series machine with the GA-1310 controller attached has several restrictions in the following COMMAND
CENTER USER mode operations:
P.11 "Launching COMMAND CENTER"
P.11 "COMMAND CENTER top page"
P.12 "Registering from COMMAND CENTER"
Launching COMMAND CENTER
The following methods for launching COMMAND CENTER cannot be used when the controller is connected to the
equipment:
Launching COMMAND CENTER by using the Document Monitor link
Launching COMMAND CENTER from Network Map (Windows Vista)
The operation for launching COMMAND CENTER differs depending on the equipment with or without the controller.
For instructions on how to launch COMMAND CENTER on the equipment with the controller, see the following section:
P.35 "Launching COMMAND CENTER from the WebTools home page"
COMMAND CENTER top page
The following link for downloading the client software cannot be used when the controller is connected to the equipment:
The [Install Software] link
Machine without the controller
All the screenshots in this manual are examples from Windows Vista.
1 RESTRICTIONS
COMMAND CENTER USER Mode
11