Turn Printer State Reply On/Off (Remote Mode) "St" 02H 00H 00H M1 - Epson PX-603F Programming Manual

6.1.5 Turn printer state reply on/off (Remote Mode) "ST" 02H 00H 00H m1

[Format]
[Parameters]
Parameter m1 is a one byte binary parameter, and indicates the setting as follows:

m1
10H
11H
[Function]
-The default environment status transmission is set. See the paragraph of status transmission for the status transmission.
-This setting depends on interfaces that receive this command. For example, this command is received with the built-in Macintosh
serial interface; the status transmission for the built-in Macintosh serial interface is set.
-If the parameter m1 is out of range, or if setting of parameter m1 is not supported by the product, this command is ignored, and the
existing setting is maintained.
-This command will be ignored if this command is not supported.
-This command is only available in Remote Mode.
Auto interface select function
-If the status transmission is ON, the interface transmits the status whether the interface is selected or the interface is deselected
by the auto interface select function.
Revision: 1
"ST" 02H 00H 00H m1
Printer State Reply
Binary state reply Off
Binary state reply On
2011/03/02
Page: 66