Unpacking; Setting Up Host - Intergraph InterRAID-12 Hardware User's Manual

u
DTP Server
u
TD-xx (desktop and deskside)
The following describes unpacking, setting up, and connecting the InterRAID-6 Expansion
Solution to your system.

Unpacking

Carefully unpack the InterRAID-6 Expansion Solution equipment, and verify that you have
the following items:
u
InterRAID-6 cabinet
u
Key for cabinet door
u
RAID disk drives
u
Diskettes containing configuration and utility software
u
Documentation
u
Antistatic wrist strap
u
Accessory pack containing a power cord, RAID SCSI cables, four plastic feet, eight cap
head screws, one hex wrench, disk drive labels, rubber pads, a blanking plate, a Drive
Labeling sheet, a Feet Installation sheet, a Power Supply Cord Selection sheet, and an
Antistatic Handling sheet
The Expansion Solution equipment may also include a RAID controller board.
CAUTION Do not remove the RAID disk drives from the antistatic bags until you are ready to install the
drives in the cabinet. Do not handle the RAID disk drives unless you connect an antistatic
wrist strap to your wrist and to a bare metal surface on the cabinet.
Retain all packaging materials. You must return the system in the original packaging to
obtain warranty service. Refer to the instructions in the back of this guide for returning
equipment to Intergraph.

Setting Up Host

The following provides instructions for setting up the host system for use with an
InterRAID-6 Expansion Solution RAID controller board.
9