Table of Contents
Advertisement
Startup Sequence
When the system boots, press
MEGARAID CONTROLLER BIOS Version x.xx Aug 1, 1996
Host Adapter-1 Firmware Version x.xx DRAM Size 8 MB
0 Logical Drives found on the Host Adapter
0 Logical Drives handled by BIOS
Press <Ctrl><M> to run MegaRAID BIOS Configuration Utility
NOTE
If you do not press
normal boot procedure.
For each MegaRAID controller in the system, the firmware version, DRAM size, and the
status of logical drives on that controller displays. When you press
Management Menu displays:
-------------- Management Menu ----------------
Configure
Initialize
Objects
Format
Rebuild
Check Consistency
Select Adapter
Disable BIOS
Management Menu Options
The Management main menu options are as follows:
Option
Configure
Initialize
Objects
Format
Rebuild
Check
Consistency
Select Adapter
Disable BIOS
+
when the following appears:
CTRL
M
+
within a few seconds of the prompt, the system continues the
CTRL
M
Description
Configures physical arrays and logical drives
Initializes one or more logical drives
Individually accesses controllers, logical drives, and physical drives
Low-level formats a hard disk drive
Rebuilds a failed disk drive
Verifies that the redundancy data is correct in logical drives using
RAID level 1, 3, or 5
Selects a MegaRAID host adapter (controller)
Disables the BIOS
79
+
, the following
CTRL
M
Advertisement
Table of Contents
Need help?
Do you have a question about the InterRAID-12 and is the answer not in the manual?
Questions and answers