HP StorageWorks 1510i - Modular Smart Array User Manual page 109

Message
07 CLONE FIRMWARE?
'<'=NO, '>'=YES
08 CONTROLLER TOO
OLD NOT SUPPORTED
09 PILOT 2 CONTRLR
NOT SUPPORTED
10 FIRMWARE FLASH
FAILED
11 CLONING REFUSED
SYSTEM HALTED
12 ONLINE UPGRADE
FLASHING FIRMWARE
13 ONLINE UPGRADE
FLASHING STARTED
14 ONLINE UPGRADE
FLASHING DONE
15 ONLINE UPGRADE
FLASHING FAILED
16 ONLINE UPGRADE
RESTARTING SYSTEM
17 ONLINE UPGRADE
COMPLETE
Type Description
In dual-controller configurations
only, the array controller has
detected a firmware version
mismatch with the two controllers
User input
and wants to copy the firmware
from the other controller onto
this controller. Firmware on both
controllers must match.
During startup, the firmware
examines the hardware to ensure
that it is supported for use with the
Error
version of installed firmware.
This controller is not supported.
During startup, the firmware
examines the hardware to ensure
that it is supported for use with the
Error
version of installed firmware.
This controller is not supported.
Error
ROM flash failed.
A firmware mismatch was detected,
message 07 CLONE FIRMWARE?
Error
'<'=NO, '>'=YES was
displayed, and the user selected <
for "No".
An online firmware update is
Informational
starting.
An online firmware update is in
Informational
progress.
An online firmware update has
Informational
completed.
An online firmware update has
Error
failed.
An online firmware update is
Informational forcing an automatic restart of the
system.
An online firmware update has
Informational
completed successfully.
1510i Modular Smart Array installation and user guide
Action
Scroll through and read the
messages on both controller LCD
panels to confirm the currently
installed firmware versions on
the controller. Then, respond
appropriately to the prompt.
< = No, do not clone.
> = Yes, proceed with the cloning.
No input = Yes, proceed with the
clone.
During a restart of the MSA
chassis, the controller with the
latest version of firmware is cloned.
If a new or replacement controller
is hot added, the firmware on
the already installed and active
controller is cloned, even if less
recent.
Contact HP support.
Contact HP support.
Download new firmware from
the HP website and initiate the
firmware update again.
If the issue persists, contact HP
support.
Firmware on the controllers must
be updated to be the same.
Download new firmware from
the HP website and initiate the
firmware update again.
If the issue persists, contact HP
support.
109