Using The Optional Rmt-4Ir Remote Unit - Gefen EXT-HDMI1.3-CAT6-4X User Manual

4x cat6 extender for hdmi
Table of Contents

Advertisement

CONNECTING AND OPERATING THE
Routing Sources using the Optional RMT-4-IR Remote Unit
There are a total of 4 buttons on the RMT-4-IR remote, which represent each of
the 4 buttons on the Receiver unit.
Example 1: Route the source connected to HDMI In 3 (from the 4x4 Matrix) on
the Sender unit to the display connected to HDMI Out 2.
Point the Remote at the Receiver unit connected to Display 2, then press button
3 on the RMT-4-IR.
The RMT-4-IR remote control unit will allow the selection of any input (source) on
the 4x4 Matrix unit can be will be routed to any of four Receiver units. Use the
information in the table above when routing the desired input to a display.
4X CAT6 EXTENDER FOR HDMI
(Matrix Mode)
Table of IR Remote Commands
for the Optional RMT-4-IR Remote Unit
RMT-4-IR Button
1
2
3
4
Source
1
2
3
4
15

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the EXT-HDMI1.3-CAT6-4X and is the answer not in the manual?

Subscribe to Our Youtube Channel

This manual is also suitable for:

4x cat6Ext-hdmi1.3-cat6-8x

Table of Contents