Brother Entrepreneur Pro PR-1000 Operation Manual page 26

q
When the following message appears, remove
the two stickers, and then re-affix them so
that the fabric can be re-hooped with the next
pattern within the embroidering area. This
time, keep the distance between stickers 5 cm
(2 inches) or more. After the stickers have
been affixed, press
Press to remove the positioning stickers
•
when it's hard to reach the stickers behind the
needles.
Note
• If the stickers are re-affixed within or near the area
where the next pattern is to be embroidered, the
stickers and the next patterns will fit within the
embroidering area more easily after being re-
hooped.
• When the following message appears, reaffix the
stickers within the embroidering area.
The message above may also appear when the
sticker is attached slightly out of the embroidering
area. In that case, reaffix the stickers so that they fit
more within the embroidering area.
r
.
s
t
If the stickers has been successfully detected,
the following message appears. Press
Hoop the fabric so that the next pattern and
the centers for the large circles of the two
marks are within the embroidering area, and
then attach the embroidery frame to the
machine.
a
Pattern to be embroidered next
b Centers of large circles for stickers
c
Embroidery sheet
When the pattern connection setting screen
(screen for connecting the selected pattern to
the previous one) appears, select the
reference edge and reference point for
connecting this pattern to the previous one,
and then press . For this example,
select the top point of the left edge, and then
press .
.
25