Troubleshooting And Quick Reference Chart - Brother Entrepreneur Pro PR-1000 Operation Manual

Troubleshooting and Quick Reference Chart

If any problems occur, refer to the following to resolve them.
Operation
1 Select the first pattern.
2 Press the pattern connection key.
3 Select the reference point of the first pattern
for connection to the second pattern.
4 Begin embroidering the first pattern.
5 Finish embroidering the first pattern.
6 Start detecting marks (2 locations).
7 Finish detecting marks.
8 Re-hoop the fabric.
9 Select the second pattern.
10 Select the reference point of second pattern
for connection to the first pattern.
11 Start detecting marks (2 locations).
12 Finish detecting marks.
13 Remove the two stickers.
14 Select the reference point of second pattern
for connection to the third pattern.
15 Begin embroidering the second pattern.
16 Finish embroidering the second pattern.
17 Start detecting marks (2 locations).
18 Finish detecting marks.
19 Re-hoop the fabric.
20 Select the third pattern.
Operation
21 Select the reference point of third pattern for
connection to the second pattern.
22 Start detecting marks (2 locations).
23 Finish detecting marks.
24 Remove the two stickers.
25 Select the reference point of third pattern for
connection to the fourth pattern.
26 Begin embroidering the third pattern.
27 Finish embroidering the third pattern.
Operation: No. 8 & 19
Issue: When re-hooping the fabric, a sticker peels off
the fabric.
Solution: The patterns cannot be connected. Restart
the procedure from the beginning with a new piece of
fabric and stabilizer in the hoop.
Operation: No. 8, 11, 19 & 22
Issue: The next pattern to be embroidered and the
centers of the large circles on the stickers do not fit
within the embroidering area.
Solution1: Change the embroidery frame to a larger
one.
Solution2: Reposition the stickers so that they fit
within the embroidering area. With the embroidery
frame remaining attached to the machine, select the
next pattern, and then continue with the procedure in
"Changing the Position of a Sticker" on page 21.
Operation: No. 10 & 21
Issue: You wish to change the selected reference
point.
Solution: The selected reference point can be
changed. For details, refer to "Changing the Reference
Edge and Reference Point for Connecting the Next
Pattern after a Pattern has been Embroidered" on page
28.
35