Canon VIXIA HV40 Instruction Manual page 100

Do's and Don'ts oo_
When the camcorder is moved from a
cold place to a warm room
e
o
o
When the camcorder is left in a humid
room
RESUMING USE
• The precise time required for water
droplets to evaporate will vary depending
on the location and weather conditions.
After the condensation warning stops
flashing, wait for 1 more hour before
resuming use.
When a cold room is heated rapidly
TOAVDID DDNDENSATION
• Do not expose the camcorder to
sudden or extreme changes in
temperature.
• Remove the cassette, place the
camcorder in an airtight plastic bag and
let it adjust to temperature changes
slowly before removing it from the bag.
WHEN
DDNDENSATIDN IS DETECTED
• The camcorder automatically shuts off,
the warning message "CONDENSATION
HAS BEEN DETECTED" appears for
approx. 4 seconds and [] starts flashing.
• If a cassette is loaded, the warning
message 'REMOVE THE CASSETTE"
appears and [] starts flashing. Remove
the cassette immediately and leave the
cassette compartment open. Leaving the
cassette in the camcorder may damage
the tape.
• A cassette cannot be loaded when
condensation is detected.
Usingthe CamcerderAbroad
PDWCr $CUrDC$
You can use the compact power adapter
to operate the camcorder and to charge
battery packs in any country with power
supply between 100 and 240 V AC, 50160
Hz. Consult the Canon Service Center for
information on plug adapters for overseas
use.
Playback co a TV SerccD
You can only play back your recordings
on TVs compatible with the NTSC
system. The NTSC system is used in the
following countriestareas:
American Samoa, Antigua, Aruba,
Bahamas, Barbados, Bermuda, Bolivia,
Canada, Chile, Colombia, Costa Rica,
Cuba, Ecuador, El Salvador, Guam,
Guatemala, Greenland, Haiti, Honduras,
Jamaica, Japan, Korea, Mexico,
Micronesia, Myanmar, Nicaragua,
Panama, Peru, Philippines, Puerto Rico,
Saint Kitts and Nevis, Saint Lucia, Saint
Vincent and the Grenadines, Surinam,
Taiwan, Trinidad and Tobago, USA,
Venezuela, Virgin Islands.