Connecting To The Ethernet Port - Epson 10600 Printer Manual

Note
To connect to a network
hub, you need a standard
RJ-45 "straight through"
network cable. If you
want to connect the
printer directly to your
computer (instead of
through a network), use
an RJ-45 "crossover"
cable.

Connecting to the Ethernet Port

To connect the printer using its Ethernet port, you need a 10/100 Ethernet
cable. Follow the steps below to connect the printer.
1. Make sure the printer is turned off.
2. Connect one end of the network cable to the 10/100 port on the back of
your printer.
3. Connect the other end of the cable to your network hub or directly to
your computer, as needed.
If you're connecting through a network, see page 1-41 for instructions on
configuring your client systems and to finish setting up the printer. If you're
connecting directly to a computer, continue with the instructions in the next
section.
1-25
Setting Up the Printer | 1-25