1-38
|
Setting Up the Printer
7. If the pattern is missing dots (as shown below) or if any are out of place
(deflected), click
Clean
the print head. Cleaning takes about 60 seconds, during which the
printer makes some noise and the
8. When the
Pause
then:
Macintosh: Click
Windows: Click
Print nozzle check pattern
The nozzle check pattern prints again.
9. If the nozzle check pattern prints correctly, click
on to "Aligning the Print Head" on page 1-39.
If the pattern is still incorrect, click
It may take several cleaning cycles to clean the print head fully.
If the lines on the pattern still appear broken after several cleaning
cycles, turn the printer off and leave it overnight, then clean the print
head again the following morning. If you still see no improvement,
contact EPSON for assistance.
1-38
and follow the instructions on screen to clean
Pause
light goes off, make sure paper is loaded in the printer,
, then click
Confirmation
Clean
light flashes.
.
Next
, then click
.
Print
, then continue
Finish
to clean the print head again.