Log Installation - Temco DV1000N/P Installation And Operating Manual

After completing Steps 1 and 2, the louvre assembly
should look like the illustration shown in Figure 31.
Models DV1000, DV1200 and DV1400: To install the
bottom louvre assembly, hook the top louvre blade ends
over the top hang tabs located at the left and right ends
of the panel opening.
Fig. 31 Louvre in place.

Log Installation

T202
Attention: Glass door should be removed when install-
Louvre in place
ing logset and prior to lighting the unit.
12/10/03 djt
1. Remove glass door (Refer to "Glass Door Removal
Procedure")
2. Remove logs from carton and inspect. Refer to Fig-
ures 32 and 33.
3. Rear log should be installed onto rear log supports.
Match up slots on rear of log with the vertical log
bracket tabs. Push log back as far as it will go.
4. The center log should be placed on the center log
supports, slots aligned with tabs, and log placed
rearward.
5. Top twigs can then be placed in their designated po-
sitions provided with pins on back logs, and grooves
on the center log. The two outside twigs provided on
the DV1400 models rest on top of the ends of the
grate. They are located and supported by the wire
formed brackets extending up from the firebox base.
(Fig. 35)
6. Place rock wool loosely along top edge of ember
retainer along entire length of ported area of front
burner. Use individual pieces of rock wool about the
size of a quarter. Rock wool should be fluffed up
and not compressed. Rock wool must be held up by
ember retainer tray. Do not allow embers to fall on
burner and cover burner ports.
7. Ember tray ends beyond burner port area and area
in front of grate may be covered with lava rock to suit
individual appearance preferences.
8. Purge lines and test pilot operation.
76657
9. Replace glass door. The door must be installed be-
fore operating the fireplace. (Refer to Page 24)
10. Flame should not impinge (touch) on logs.
WARNING: Do not place rock wool, lava rock
or any other materials on the burner. Use only
certified material supplied with this fireplace.
Using uncertified materials will void the war-
ranty.
T202
Fig. 32 Correct log placement for DV1000 and DV1200.
Fig. 33 Correct log placement for DV1400.
Temco DV1000/1200/1400 Series
TL119
DV1000/DV1200
logs
12/11/03 djt
TL119
TL120
25