Log Installation - Temco DV1000MBN Homeowner's Installation And Operating Manual

Temco DV1000/1200/1400MBN Series
2. Once the second louvre blade has engaged the top
tab of the end brackets, swing the bottom of the
louvre assembly inward so the louvre hangs flush
with the fireplace face.
After completing Steps 1 and 2, the louvre assembly
should look like the illustration shown in Figure 31.
Models DV1000MBN, DV1200MBN and DV1400MBN:
To install the bottom louvre assembly, hook the top
louvre blade ends over the top hang tabs located at the
left and right ends of the panel opening.
Fig. 31 Louvre in place.

Log Installation

Attention: Glass door should be removed when
installing logset and prior to lighting the unit.
1. Remove glass door (Refer to "Glass Door Removal
Procedure")
2. Remove logs from carton and inspect. Refer to
Figures 32 and 33.
3. Rear log should be installed onto rear log supports.
Match up slots on rear of log with the vertical log
bracket tabs. Push log back as far as it will go.
4. The center log should be placed on the center log
supports, slots aligned with tabs, and log placed
rearward.
5. Top twigs can then be placed in their designated
positions provided with pins on back logs, and
grooves on the center log. The two outside twigs
provided on the DV1400MBN models rest on top of
the ends of the grate. They are located and sup-
ported by the wire formed brackets extending up
from the firebox base. (Fig. 35)
6. Place rock wool loosely along top edge of ember
retainer along entire length of ported area of front
burner. Use individual pieces of rock wool about the
size of a quarter. Rock wool should be fluffed up
and not compressed. Rock wool must be held up by
ember retainer tray. Do not allow embers to fall on
burner and cover burner ports.
20
7. Ember tray ends beyond burner port area and area
in front of grate may be covered with lava rock to
suit individual appearance preferences.
8. Purge lines and test pilot operation.
9. Replace glass door. The door must be installed
before operating the fireplace. (Refer to Page 23)
10. Flame should not impinge (touch) on logs.
WARNING: Do not place rock wool, lava rock or any
other materials on the burner. Use only
certified material supplied with this fireplace.
Using uncertified materials will void the
warranty.
T202
Fig. 32 Correct log placement for DV1000MBN and
DV1200MBN.
Fig. 33 Correct log placement for DV1400MBN.
TL119
TL120
76658