Spinner Nxt Assembly And Setup - Star Trac Spinner v Owner's Manual

Table of Contents

Advertisement

SPINNER
NXT ASSEMBLY AND SETUP
®
Use the following procedures to unpack and assemble your
U
NPACKING
Prepare the area that you will be unpacking and assembling the bike to be free from debris that may cause damage. Observe all safety precautions and
care while unpacking and assembling the bike. Position the shipping carton so the "Heavy End" logo is located at the bottom. Open the top of the
carton and fold back all four flaps. Carefully tilt the box forward so that the box may be lifted to expose the bike. Remove all parts from the shipping
carton and foam inserts, and verify that the following parts are included in your shipment:
NXT Parts List
Description
Main Frame Assembly
Handlebar Post
Handlebar w/ Grip & Water Bottle Holders
M8x1.25, 16mm Flat Head Screw
M8x1.25, 16mm Socket Set Screw
Seat Post
Seat Slider Assembly w/ Saddle
Pedals (set of two)
Front Leg Assembly w/ Transport Wheels
Spare Parts Kit- Save the box of spare parts in a safe place so you have service parts when needed in the future.
Take time now to enter your Spinner
member). If parts are missing, or if you have any operational questions, please call Star Trac's Service department at (800) 503-1221; have your serial
number ready.
Serial No._____________________________________________
NOTE: If you are missing any of the parts listed above, inspect the packing material and the box for items that may have been overlooked.
If parts are missing, or if you have any product questions, please call Star Trac's Service Department at (800) 503-1221, p lease have your Spinner's
serial number ready.
CAUTION:
Damage to the bike during assembly is not covered as part of the limited Star Trac® warranty. Take care not to drop or lean the bike on
the handle bar pop-pin. Carefully stand the bike up in the normal upright position on a stable surface so it will not tip over during assembly.
Page 8
SPINNER
Qty.
1
1
1
2
1
1
1
1
1
NXT serial number in the space below (serial number is located on the bottom cross
®
NXT.
®
Description
Rear Leg Assembly
M10x1.5, 55mm Button Head Screw
M10x1.5, 65mm Button Head Screw
M10x1.5 Nyloc Hex Nut
10mm Washer, Flat
Wrench Hex, 5mm
Wrench Hex, 4mm
Multi-Wrench
Spare Parts Kit
(includes brake pad and pedal straps)
Qty.
1
4
4
8
16
1
1
1
1
SPINNER
OWNER'S GUIDE
®

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Spinner nxtSpinner proSpinner elite

Table of Contents