Adjustments - Star Trac Spinner v Owner's Manual

Note:
If the chain is stretched beyond adjustment, the replacement
of the chain is recommended. Proceed to "Chain
Replacement" for further instructions.
When alignment is at the optimal adjustment, the chain will
run smoother and quieter.
9. Tighten the adjustment lock nuts and axle nuts on both sides.
10. Install the chain guard shroud and re-test the bike.
C A
LUTCH DJUSTMENT (Elite Only)
1. Using a 3mm Allen Wrench, remove the three screws supporting the
plastic chain guard shroud.
2. Using a 3mm Allen Wrench, remove the four screws supporting the
COG guard cover. (Figure 7)
3. If the torque is not 45 ~ 50 ft-lbs. using a 5 mm Allen Wrench, give
each of the set screws a little clockwise turn. A "little turn" is about 10
degrees. (Figure 8A & 8B)
Note:
Be sure and turn all 5 set screws so they have equal pressure
to obtain the proper adjustment. Recheck the torque for
different positions around the clutch. If it is still not 45 ~ 50
ft-lbs, repeat the procedure.
The goal is to make all the set screws have the same
pressure on the clutch.
4. Test the clutch system for proper operation for normal riding use.
Observe all safety practices.
Page 29
Adjustment
Screws
Axle Nuts
Figure 6A. Pro/Elite
Chain Guard Side
COG Cover
Figure 7.
Figure 8A.
SPINNER
Figure 6B. Pro/Elite
Opposite Side of Chain
Guard
Set
Screws
Figure 8B.
OWNER'S GUIDE
®