Source Technologies ST9530 User Manual page 52

MICR Password Error
Password Not Enabled Error
Invalid AES/DES key
Purge Audit Report, Then
Format
File System Error Can't Open
File
Can't Create Node
Secure File Not
Unlocked/Opened/Written/Read
Secure MICR Printer User's Guide
September 2005
Password Match
Error
48
characters.
Password sent does
not match the
current stored
password.
A secure command
was sent without the
password being sent
first
Invalid hex digit or
length of decryption
key
An SFF command
was received, but
there is audit data in
flash which should
not be erased
There was an
internal error while
trying to access
flash for audit trail
There was
insufficient memory
to track another
audit job
There was an
internal error while
trying to access
Flash for an STL or
STP command
© Source Technologies
All Rights Reserved
software, it must be
eight characters long.
Check the Password
Command in your
software.
Check software to
ensure that password
is sent before any
secure commands
Check syntax of
SETAESKEY or
SETDESKEY
command
Purge the audit data,
then resend the SFF
command
Check that Flash is
installed and not full
Turn printer off and
back on, then retry. If
the problem recurs,
call Tech Support
Print the menus to
ensure that Flash is
installed. Print a
directory of Flash to
ensure that is it not
write protected or full.
If error occurs on
STP command,
check to confirm that
the resource is stored
in Flash.