Source Technologies ST9530 User Manual page 25

Print MICR CMC7 Font
&%SM7
ddd...ddd
$
Prints the specified data in the CMC7 MICR font which is used in Europe and South
America. The font and its correct spacing begins at the current cursor position modified by
the MICRpoint adjustment setting at the start of the command. After the terminator is sent,
the printer will return to its default font, and the MICR count will be decremented by one.
Upon receiving this command the printer will check to ensure a MICR toner cartridge is
installed and set the copies parameter to 1. See Appendix B for CMC7 character mapping.
Print Secure Numeric Font
&%SMF
ddd...ddd
~
The dollar sign ($) is not a command terminator for this command. For both security fonts
the tilde ~ (hex 7E) is the command terminator since the dollar sign is a valid character.
Print ICR Secure Numeric Font &%SMIxxxxxx~
&%SMI
xxxxxxxx
~
Print MicroPrint Line
&%SMM
xxxxxx
!
$
If the exclamation point (!) is used, the "MP" designate will print just above and to the right
of the last character. This is optional and is typically used to notify the check recipient of
the presence of MicroPrinting. Only 0-9, A-Z (upper and lower case) print. Special
characters and spaces disappear.
Secure MICR Printer User's Guide
September 2005
&%SM7ddd...ddd$
Lead in sequence
Data to be printed in CMC7 font
Command terminator
&%SMFddd..ddd~
Lead in sequence
Data to be printed in this font
Command terminator
Lead in sequence
Data variables to be printed in this font
Command terminator
&%SMMxxxxxxxxx!$
Lead in sequence
Data to be printed in this font
MP designator (optional)
Command terminator
21
© Source Technologies
All Rights Reserved