Source Technologies ST9530 User Manual page 42

$
Ends the Audit Record and the PJL job (ignored if there was no Start Audit Record
Command).
Audit Report Field One
&%SQ1
d..d
$
This command identifies the data to be printed in the first column of the report. It is a
maximum of 14 characters in length. If less than 14 characters are sent, the printer fills the
field with spaces when the audit report is printed. This field is recorded in the audit report
only, it is not printed on the check.
Audit Report Field Two-MICR Line
&%SMD or &%SM7
d..d
$
This command identifies the data to be printed in the second column of the report. It is a
maximum of 40 characters in length.
Audit Report Field Three
&%SQ3
d..d
$
This command identifies the data to be printed in the third column of the report. It is a
maximum of 40 characters.
Audit Report Field Four
&%SQ4
d..d
~
This command identifies the data to be printed in the fourth column of the report. It is a
maximum of 16 characters in length. Since a total of this field can be provided at the end of
the Audit Trail Report it is typically used for the convenience amount field. NOTE: This is the
only command where the $ is not a command terminator. The tilde ~ (hex 7E) acts as the
command terminator.
Secure MICR Printer User's Guide
September 2005
Command terminator
&%SQ1d..d$
Lead in sequence
Data to be stored
Command terminator
&%SMDd..d$ or &%SM7d..d$
Lead in sequence
Data to be printed
Command terminator
&%SQ3d..d$
Lead in sequence
Data to be printed
Command terminator
&%SQ4d..d~
Lead in sequence
Data to be printed
Command terminator
38
© Source Technologies
All Rights Reserved