Source Technologies ST9530 User Manual page 26

Load Flash Resource
&%STL
xxxxx
yyyyyy
z
dd...dd
Resource number values may be between 00001 to 32767. Values of 10000 and above
are password protected and will require the user to enter MICR mode with a valid password
before they can be unlocked with the STP command. Values below 10000 will be
unsecured.
Resource number 5001 is reserved for the Audit Trail overlay, see chapter 7.
Format Flash Memory
&%SFF
$
This command formats flash memory. A valid password command must precede this
command.
Caution: All flash contents will be lost. This includes all electronic forms, signatures, logos,
etc.
Secure Flash Resource Unlock Command
&%STP
xxxxx
$
Unlocks a secure flash resource.
Tray Lock Command
&%STTL
#
$
This command prevents other applications from accessing a particular printer paper tray.
Secure MICR Printer User's Guide
September 2005
&%STLxxxxxyyyyyyzdd....dd
Lead in sequence
Resource number in decimal, must be 5 digits
Byte count of resource file in Hex, must be 6 positions
Format of the resource file
S = Single byte binary format
D = Double byte text format
Flash resource file. e.g. forms overlay, signatures etc.
&%SFF$
Lead in sequence
Command terminator
Unlock flash resource command
Flash resource number, must be 5 digits
Command terminator
&%STTL#$
Lock tray command
The tray to be locked (choose from 1, 2 or 3 only)
Command terminator
22
&%STPxxxxx$
© Source Technologies
All Rights Reserved