Source Technologies ST9530 User Manual page 37

The commands in Figure 7.1 in order of appearance:
&%STFPASSWORD$
&%SMCP0001$
&%STP10001$
&%STP20000$
&%1B26...3358$
&%1B$(s1p16v0s3b4148T PCL sequence which changes the font to Univers 16 point. After
&%1B$(3@
&%SMF$2014.44~
&%1B$(s0p12h1s0b4099T PCL command to change the font to Courier 12 pitch Italic. Print
&%1B$(3@
&%1B$(20000X!
&%1B$(3@
&%1B$&f0S
&%1B$*p296x3184Y
&%SMD....$
&%1B$&f1S
Secure MICR Printer User's Guide
September 2005
Password Command.
MICR Definition Command with the count set to one.
Unlock Flash Resource number 10001.
Unlock Flash Resource number 20000.
PCL sequence in hex which sets the page format and enables
macro number 10001.
the check serial number prints (1000), the printer is returned to
its default font with the following command.
PCL command to return to default font.
Print Secure font command. Note: The tilde ~ is the
command terminator.
PCL Fonts from the Front Panel menu for a list of fonts with
their call commands.
PCL command to return to the default font.
PCL command to print font number 20000. In this example font
20000 is a signature previously loaded into flash memory. Here
we call it and print it with an exclamation point (!).
PCL command to return to the default font.
PCL command to Push (store) the current cursor position.
PCL command to move the cursor to 296X , 3184Y. At 300
units of measure, this is .97 inches across and 10.61 inches
down. We are precisely positioning the MICR line.
Print E-13B MICR Command. Prints the MICR line. Note the
MICR font character mapping in Appendix A.
PCL command to Pop (return) the cursor to the pushed position.
33
© Source Technologies
All Rights Reserved