Removing the bezel
Important: Before you install optional hardware, make sure that the server is
working correctly. Start the server, and make sure that the operating system starts,
if an operating system is installed, or that a 19990305 error code is displayed,
indicating that an operating system was not found but the server is otherwise
working correctly. If the server is not working correctly, see the Hardware
Maintenance Manual for diagnostic information.
To remove the bezel, complete the following steps:
1. Read the safety information that begins on page vii and "Installation guidelines"
2. Unlock the side cover.
3. Position your finger on the depressed area on the left side of the bezel and
4. Press the retention tabs 1 on the hinge assembly toward each other and pull
on page 9.
Note: You must unlock the side cover to remove the bezel.
rotate the bezel away from the server.
the hinge assembly out of the chassis.
Chapter 2. Installing options
13