Display; Sequential Setup; Auto Sequence With Front Panel And Remote Control - Digimerge Touch DH200 Series Instruction Manual

Using the Main Menu

DISPLAY

Use the Display menu to configure
the OSD and Auto Sequence
settings.
Figure 12.0 Display menu
To change display settings:
1. Select the DISPLAY SETUP tab, and
configure the following:
• STATUS BAR: Select to Show or Hide the
status bar on the OSD.
• CAMERA: Select to show the CAMERA NO. or
the CAMERA TITLE or both.
• BORDER LINE: Set the color for the borders
of the OSD: WHITE, BLACK, DARK GREY, or
GREY
• BACKGROUND: Set the background color for
disconnected cameras on the main display:
GRAY, WHITE, BLUE, or DARK GREY
• SPLIT MODE: Set up to four split-screen
display modes
• : Select
QUICK SETUP
the quick setup menu
2. Press ENTER to save your changes and
exit.
22
to enable/disable
ON/OFF

Sequential Setup

Configure Sequential Setup (Auto Sequence)
settings.
Figure 12.1 Auto Sequence setup
To configure Sequential Setup settings:
1. Select the SEQUENTIAL SETUP tab and
configure the following:
• DWELL TIME: Set from 1~30 seconds.
• SEQ. MODE: Set the display mode, from single
channel full-screen to 8-channel
split-screen
must
You
NOTE:
display modes to enable Auto Sequence
mode. If none of these modes are
selected, Auto Sequence
• FULL SCREEN: Select channels for
full-screen display. If selected, these
channels will appear in full-screen during
Auto Sequence mode
2. Press the ENTER button to save your
settings and enable Auto Sequence. Auto
Sequence will immediately begin.
3. Press the DISPLAY button to stop Auto
Sequence.
Auto Sequence with Front Panel and
Remote Control
Once you have configured the Auto Sequence
settings in the Display menu, you can use the
remote control to turn Auto Sequence on/off.
To enable/disable Auto Sequence:
1. Press and hold
remote control for 2 seconds.
2. To exit press . The main screen will
return to a quad display.
select one of these
will not
begin.
on the front panel or