Hard Drives; Removing And Replacing The Hard Drive - Gateway E-4400 System Manual

Hard drives

Removing and replacing the hard drive

The hard drive is secured to a mounting plate that snaps out of and into the
chassis.
To replace the hard drive:
1
Turn off the system and disconnect the power cord, modem cord (if
installed), and all external peripheral devices.
2
Open the case (see "Opening the case" on page 17), observing the "Static
electricity precautions" on page 15.
3
Locate the 3.5-inch hard drive and mounting plate ring.
4
Lift the ring slightly, then pull it towards the center of the drive until
the spring latch releases. Lift the drive out of the chassis.
5
Remove the mounting plate from the old drive by lifting and sliding one
tab at a time until they unlock. Lift the mounting plate off the drive.
6
Position the new drive upside down in the mounting plate and snap it
into place.
7
Place the drive back into the drive bay.
8
Connect the power and data cables to the back of the drive. (See drive
documentation for proper drive jumper settings and cable orientation.)
28
Replacing and Adding Drives
Tabs