Video Problems - Gateway E-4400 System Manual

Video problems

The system is running but there is no display
Probable Cause
The monitor is not turned
on.
The monitor's data cable
is not connected.
The connector or cable is
damaged.
The monitor is defective.
The monitor's brightness
and contrast controls are
turned down.
The video card is not
seated correctly.
The video card is not
compatible with the
system.
Important
The text on the display is dim or difficult to read
Probable Cause
The monitor's brightness
and contrast controls are
turned down.
Sunlight is glaring off the
display.
The CRT may be old.
Solution
Make sure the monitor is plugged in and turned
on. If power is applied to the monitor, the green
power LED should illuminate.
Make sure the monitor's data cable is
connected to the video controller on the back
of the system.
Check the connector and cable for bent or
damaged pins.
Connect a working monitor to the computer.
Adjust the brightness and contrast knobs to the
center position.
Open the system and reseat the video card.
Make sure the card is compatible with your
system. Try a different PCI video card.
Some systems may have a built-in video adapter, so there
may not be a video adapter to remove and replace.
Solution
Adjust the brightness and contrast knobs until
the text becomes clear.
Position the monitor away from the sun or
window.
Replace the monitor.
Video problems
83