Epson PowerLite 7850p User Manual page 72

note
If you want to enter a blank
space, use the space character
that comes before the capital
letter A.
If you want to enter
numbers, press the
Num
button on the remote
control. The button lights up
to indicate that the numeric
keypad mode is active. Press
the button again to
Num
exit numeric keypad mode.
note
The projector keyword
changes each time you turn
the projector off and then on
again, or remove and
reinsert the 802.11b card.
Check the keyword on the
EasyMP Network screen
whenever you start EasyMP,
and enter that keyword on
your computer. You can't
connect using a previous
keyword.
Presenting Through a Wireless Network
72
4. Make sure the projector has a unique name, so you can identify it
when connecting to it from your computer.
If you need to rename it, highlight the
, then press
Projector name
the text box. Then highlight the text box and press
outline of the text box turns green to indicate you are in input
mode. Tilt the
alphabetical order, or down to select letters in reverse order; then
tilt the button to the right to move to the next character
position. When done typing the new name, press
5. To enable your computer to find the projector on the network,
select the appropriate
■ Select
ESSID ad hoc
or ESSID identifier (see page 75). Then highlight the
text box, press
ROOM"). When you're done, press
ESSID is case-sensitive (if you enter the name in uppercase on
the projector, you must type it the same way on the computer
connecting to the projector).
■ Select
Channel ad hoc
channels instead of ESSID names to identify devices on the
network. Then select a channel number in the
box and press
for Macintosh.)
6. If you want to create a password for remote access to the
projector, highlight the
press , and enter a password of up to 8 alphanumeric
Enter
characters. When you're done, press
7. If you want to set up a security keyword so that only people who
are in the same room as the projector can access it, turn
on. Then when you want to connect to the projector, it
keyword
displays a randomized four-digit number or "keyword" on the
screen. When prompted by NS Connection, you can enter the
keyword on your computer to connect (see page 92).
Clear
on the remote control to clear
Enter
button up to select individual letters in
Ad hoc mode settings
if your network card supports an SSID
, and enter a name (for example, "CONF
Enter
if your network card supports using
. (Channel ad hoc mode is not supported
Enter
Password for WEB control
Enter
button next to
. The
Enter
.
Enter
:
ESSID
. Note that the
Enter
text
Channel
checkbox,
.
Projector