Epson PowerLite 7850p User Manual page 154

note
To enter numbers with the
remote control, press the
button. When the
Num
button lights up, the
numeric keypad is active.
Press the button again
Num
to exit numeric keypad
mode.
note
Use the button on the
remote control to enter
letters. Press the top of the
button to scroll through
capital letters, and the
bottom of the button to scroll
through lowercase letters.
You will also see
punctuation marks, such as
a period (.) and symbols,
such as @. When you see the
letter or symbol you want,
press . Then press the
Enter
right side of the button to
move to the next position.
To correct a mistake, press
the left side of the button to
return to the previous
Managing Projectors
154
You see the following screen:
6. For Mail Notification Settings, select
remote control.
7. Highlight the
IP address of SMTP server
The outline of the box turns green to indicate you are in input
mode. You can enter numbers between 0 and 255. However, you
cannot use the following IP addresses: 255.255.255.255,
224.0.0.0, or 127.x.x.x (where x is a number between 0 and 255).
8. Highlight the
Port Number
SMTP server port number. The default value is 25, but you can
enter numbers between 1 and 65535.
9. Highlight the box for
Enter the e-mail address for the first computer that you want to
receive e-mail alerts. You can enter a maximum of 53 single-byte
alphanumeric characters.
10. If you want to send e-mail alerts to one or two other computers,
enter addresses for those computers in
and
Destination address 3
11. Select the conditions under which an e-mail alert will be sent.
and press
ON
box and press
box and press
Enter
Destination address 1
Destination address 2
.
on the
Enter
.
Enter
. Then enter the
and press .
Enter