Solving Problems
180
Solving Problems with the
Image or Sound
No image appears on the screen.
Check that the P power light is green, not flashing, and the lens
■
cap is off.
■
The projector may be in sleep mode. If the P power light is
orange, press the
Power
■
If the power was switched off and then on again, the projector
may still be cooling down. Wait until the power light stops
flashing and remains orange; then press the
Try pressing the other
■
the projector.
Press the
■
A/V Mute
turned off temporarily.
The attached computer may be in sleep mode or displaying a
■
black screen saver. Try pressing a key on the computer.
You've connected a computer and see a blue screen with the
message
displayed.
No Signal
Make sure the cables are connected correctly, as described in
■
Chapter 3.
Try restarting your computer.
■
If you've connected a computer and one or more video sources,
■
you may need to press one of the
or remote control to select the correct source. Allow a few seconds
for the projector to sync up after pressing the button.
button to turn the projector on.
button on the remote control or on
Power
button to make sure the picture has not been
buttons on the projector
Source
button again.
Power