Aligning Extensions - Craftsman 113.29921 Owner's Manual

Aligning Extensions
1. Stand saw upright on legs Roll saw over onto front
then up onto feet,
WARNING: The saw is heavy. To avoid back injury,
get help to lift the saw. Hold the saw close to your
body. Bend your knees so you can lift with your
legs, not your back.
2 Line up the front edge of extension with the front edge
of the table Pul! up on front and rear of sheet metal
side extension so it is higher than table Using a block
of wood and hammer as shown, tap the extension
down until it is even with table top Recheck alignment
of front edge of table and extension Tighten front and
rear extension mounting nuts only,
WARNING: Table extensions must be installed,
Front edge of table and extensions must be lined
up. An uneven front edge can twist the fence guide
bar. Twisted guide bars can misalign fence. A mis-
aligned fence can cause binding or kickback. You
could be hit or cut.
3 Using the block of wood, check to see if center of
extension is flush with table top If adjustment is
needed, push the table top into alignment and tighten
center two mounting nuts
4, Repeat steps 2 and 3 to atign the other extension
Line Up Front
Of Extension
1 From the bag labeled "Large Parts" remove the follow-
ing hardware;
1 Wire Tie
2 Use a hammer to lightly tap the pointed tab on the wire
tie into the hole provided on side of cabinet Route
motor cord from inside cabinet through the wire tie
Secure cord in wire tie Keep any extra cord on outside
of cabinet Do not push extra cord inside cabinet,,
Tie
Extension
Removed for
Picture Clarity
Wire Tie
17