Aligning Table Extensions; To Raise Extension - Craftsman 113.221611 Owner's Manual

3 Install left table extension and install seven
screws using 5/32 inch hex L wrench Just start
screws
ALIGNING TABLE EXTENSIONS
NOTE; The table extensions must be the same
height as the table and level,
Place combination square on table and extension,
"-_ EXTENSION SHOULD
BE SAME HEIGHT
AS TABLE
TO RAISE EXTENSION
1, If extension is low loosen three screws on top of
the table extension A, B, and C See illustration
2, Tighten screws D, E, F, and G underneath table
extension to raise extension even with table top
front and rear
3, Check height with square and tighten A, Band C
4, Repeat for left extension
L==J I"
l
EXTENS{ON
13