Eternusmgr For Windows; Starting Up Eternusmgr - Fujitsu ETERNUS User Manual

Chapter 3 Startup and Shutdown
> 3.2 ETERNUSmgr for Windows®
nn in Snnstxpoll shows the order of priority. Set the priority sequence. Consult with the server
administrator before making this setting.
[Example]
# ln -s /etc/init.d/stxpoll /etc/rc2.d/S98stxpoll
From the next startup of Solaris OS, HP-UX, AIX, and Linux the ETERNUSmgr daemon will start
automatically. Refer to
manually shut down ETERNUSmgr.
Check the log files to see if ETERNUSmgr for Solaris OS, HP-UX, AIX, and Linux is communicat-
ing with the target devices after automatic startup.
3.2 ETERNUSmgr for Windows®
Once installed, ETERNUSmgr for Windows® is registered as a service with the following condi-
tions:
• Service Name: STXPOLL
• Condition: not displayed (=shutdown)
• Startup: automatic
This service will start up automatically the next time the server is started
After installation, certain parameters must be set before you can use ETERNUSmgr. See
"Chapter 2 Setup" (page 15)
Once the necessary parameters have been set, follow the instructions in
ETERNUSmgr" (page 42)
3.2.1

Starting Up ETERNUSmgr

Perform the following to manually startup ETERNUSmgr for Windows®:
Procedure
1
After ETERNUSmgr has started up, you need to view the log file to confirm whether or not
ETERNUSmgr is in communication with the target device. If using the E-mail notification
function, also check that E-mail notification of ETERNUSmgr startup and changes in the target
device states is received.
ETERNUSmgr startup can be confirmed by:
• In the control panel or in management tool services, make sure that "STXPOLL" is activated.
• Checking the log, and making sure that communication with the target device is normal.
P2X0-0202-04ENZ0 ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
"3.1.2 Shutting Down ETERNUSmgr" (page 41)
for details on how to perform these settings.
to startup ETERNUSmgr manually.
Select the [STXPOLL] service from [Services] under [Administrative Tools] on
the [Control Panel], and click the [Start] button.
42
for details on how to
"3.2.1 Starting Up
End of procedure
Copyright 2009 FUJITSU LIMITED