E-Mail Notification Settings - Fujitsu ETERNUS User Manual

Chapter 2 Setup
> 2.3 Setting Items
[Example]
BUSY_TIME=1800
2.3.2

E-mail Notification Settings

This section explains how to setup the E-mail notification function. See
(page 54)
Admin Mail Address
This parameter is used to specify an address to which to send the E-mail generated in the event
of change in the target device status. Usually this is the address of the target device administra-
tor.
The E-mail notification function is disabled if this parameter is omitted.
[Parameter]
ADMIN_MAIL (up to 64 characters)
[Example]
ADMIN_MAIL=admin@domain-name.com
To set multiple E-mail addresses, use a comma with no spaces between each address.
ADMIN_MAIL=admin1@domain-name.com,admin2@domain-name.com
Alarm Mailing Interval
This parameter is used to specify the interval for sending generated E-mail in the event of a fail-
ure or abnormality in the machine. Units are seconds.
Set the interval in units of seconds within the range of 1 ~ 65535. Set this parameter only if you
wish to send E-mail with timing different from the specified Polling Interval. For example, by set-
ting this parameter, you can set a short Polling Interval and long Alarm Mailing Interval. This will
allow any device errors that may have occurred over this interval to be collected and sent
together with other E-mail messages.
This parameter is not a required setting. If omitted, the default value will be the same as the
Polling Interval.
[Parameter]
MAIL_SEND_TIME (1-65535)
[Example]
MAIL_SEND_TIME=300
This specifies the Alarm Mailing Interval (time between the sending of one notification E-mail
message to the next) for sending E-mail.
Due to network or device load the time to send the E-mail may exceed the expected time. In such
cases, the E-mail sending times are recalculated the same way as for the polling time.
P2X0-0202-04ENZ0 ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
This setting is not described in the initial setup file. Add if necessary.
This setting needs not be changed.
for the content of E-mail messages provided by this function.
22
"6.3 E-mail Messages"
Copyright 2009 FUJITSU LIMITED