Fujitsu ETERNUS User Manual page 23

Chapter 2 Setup
> 2.3 Setting Items
When the Polling Interval and the Alarm Mailing Interval are different:
(Example) Polling Interval: 300 sec. (5 min.) Alarm Mailing Interval: 1200 sec. (20 min.)
Polling time
Get
information
Send mail
Mail contents
Mail Server Address (ETERNUSmgr for Windows® only)
This parameter is used to specify the address of the mail server that will receive the E-mail notifi-
cations from ETERNUSmgr.
E-mail notification is then routed to the specified Admin Mail Address by the mail server specified
here.
[Parameter]
ADMIN_MAILSV
[Example]
When the Mail Server Address is "mailsv.domain-name.com".
ADMIN_MAILSV=mailsv.domain-name.com
Mail Server SMTP Port (ETERNUSmgr for Windows® only)
This parameter is used to specify a SMTP port No. for the mail server (ADMINS_MAILSV) when
the ETERNUSmgr server is running on Windows®.
[Parameter]
SMTP_PORT (1-65535)
P2X0-0202-04ENZ0 ETERNUS Disk storage systems ETERNUSmgr User Guide -Introduction-
Unless there is some special reason to change this parameter, it is
recommended to keep the default. For this reason the parameter is initially
commented out.
0 sec 300 sec
second
1st time
time
Activate
information
1st time
Activate
information
• This parameter is initially commented out.
• Normally, the SMTP port is 25. However, if the SMTP port for the
mail server is other than 25 for some reason, correct this parameter
to match.
600 sec 900 sec
fourth
third time
time
fault 1 fault 2
detected detected
23
1200 sec
fifth time
second
time
fault 1
detected
fault 2
detected
Copyright 2009 FUJITSU LIMITED